Auto Mate 5104A Manual de Instruções descarregar pdf (Página 15)

Runtime Reset

Press and release , then press and release

If more time is needed while remote start is active, runtime reset will

reset the runtime counter to the pre-programmed setting.

Note

Remote Start must be On to use this feature.

* See “Alarm Features” on page 14

Remote Pairing

The following instruction will step you through the remote pairing op-

eration.

1. Open at least one of the vehicle’s doors.

2. Turn the key to the ON position.

3. Within 5 seconds press and release 1 time the Control button on

the Control Center.

4. Within 5 seconds, press and hold the Control button. The status

LED will ﬂash one time and the siren will chirp once to conﬁrm the

system is ready for remote pairing.

5. Release the Control button.

6. Press/hold the remote

until the transmit LED turns on solid.

The siren emits one sound to conﬁrm learning.

Note: the 2-way remote conﬁrms by playing tones as well.

7. Repeat for each remote control to be learned (up to four)

8. Turn the ignition off or wait 60 seconds to exit learning, the siren

emits 2 sounds to conﬁrm.

Pairing will exit if:

s There is no activity for 60 seconds

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 36 37

Sem comentários

Auto Mate 5104A Manual de Instruções Página 15